HEATSHIELD PROTECTION STICKY SHIELD 3MM X 1200MM X 900MM

This stick-on heat shield can reflect over 90 percent of radiant heat.

HP Sticky Shield™ is the ultimate way to stop heat from radiating into the driver’s compartment of your ride. Made from a dense layer of 1/8-inch-thick proprietary Kool Core™ insulation and shielded by a rugged layer of 3 mil-thick aluminium, HP Sticky Shield™ may be cleaned after installation and is resistant to the elements. The heavy-duty peel-and stick adhesive backed heat barrier will bond to almost any clean surface, although it is not recommended for unfinished fiberglass or carbon fiber. It is the perfect radiant heatshield for transmission tunnels, mufflers, catalytic converters, DPFs, turbos, downpipes and exhaust systems.

HP Sticky Shield™ can be used with less than 1 inch of airspace. However, when used with 1 inch or more of airspace, this peel and stick heat shield is capable of shielding over 90 percent of heat. Did that set of long-tube headers on your Mustang, Camaro, Challenger, or tuner move your catalytic converter to where there are no factory heatshields? Use self-stick insulation to stop the heat. That Jeep getting some serious heat in the transmission tunnel or from the cat? HP Sticky Shield™ it away.

HP Sticky Shield™ is asbestos-free and designed to be used under the vehicle on the floorplan, firewall, transmission tunnel and more. This sticky heat shield is not designed to be used underneath carpet. Use the included Cool Foil Tape™ to seal seams when putting two of these heatshields together and to protect the edges of HP Sticky Shield™. You can even use the tape to repair any damage caused to HP Sticky Shield™ from on- or off-road hazards.

Features:

– Capable of reflecting over 90% of radiant heat

– Flexible, bends and conforms to almost any shape

– Perfect for Jeeps, Broncos, or other 4 X 4 vehicles

– Adhesive backing sticks to almost any clean surface

– Can be cleaned after installed